VOLKTEK NSH-9308P Bedienungsanleitung PDF herunterladen (Seite 8)

because the IP address of this Switch has been changed.

2.1.1.2 Relocate HTTP port number

The default port number of HTTP access is 80, but unauthorized user may intrude this switch if he

knows the IP address of this switch. You may relocate this port number to other value, from 1024 to

65535. Once you change the port number of HTTP access and implement new setting, you will lost

current connection and you must access the Switch by new setting:

http://192.168.223.100:port_value

2.1.1.3 Tag VLAN management group

At first time you turn on this Switch, all ports belong to default VLAN ID group (VID=1), so they can

communicate to each other, and any port can be used as web management port to access this

Switch. But, for example, if you create VLAN ID=10 and assign port 7, 8 to this VLAN, then create

another VLAN ID = 20 and assign port 5, 6 to this VLAN, 3 VLAN groups will be shown on VALN

group table after you implement these settings. At this time, the management VLAN still remains on

VID=1 group, you can only perform web management through ports assigned to this VLAN (port 1, 2,

3, 4). If you want to perform web management from other port in existing different VLAN group, for

example port 8 in VID =10, you must go to system configuration page, and select Tag VLAN

Management Group to 10, then press “Apply“ to implement new setting. Therefore, you can perform

web management from ports assigned to management VLAN.

IF you forget the setting about management, there are two ways to solve this condition below.

(1) Through console port, change VLAN ID of management VLAN.

(2) Press “Reset” button few seconds, let system return to default settings.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 30 31

Keine Kommentare

VOLKTEK NSH-9308P Bedienungsanleitung Seite 8